EN
SR EN ISO 11297-3:2019
Sisteme de conducte de materiale plastice pentru renovarea reţelelor de evacuare şi de canalizare, subterane, sub presiune. Partea 3: Căptuşire cu ţevi cu ajustaj de strângere
This document, in conjunction with ISO 11297-1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of underground drainage and sewerage networks under pressure. It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to polyethylene (PE) pipes of either solid wall single layer or co-extruded layer construction, which is reduced in the factory or on site to provide a close-fitting independent or interactive pressure pipe liner, as well as associated fittings and joints for the construction of the lining system. It is not applicable to PE coated pipes having a peelable, contiguous, thermoplastic additional layer on the outside of the pipe. It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature. NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see ISO 4427-1:2007, Annex A.
Status :
Anulat
Data aprobării : 29.03.2019
Data anulării : 31.08.2026
Număr de pagini : 30
ICS : 23.040.20 Tevi din materiale plastice,23.040.45 Racorduri din materiale plastice,91.140.80 Sisteme de evacuare a apei,93.030 Sisteme de canalizare externe
Comitet tehnic : 108 - Materiale plastice şi cauciuc, metode de analiză şi produse
- Inlocuieste SR EN ISO 11297-3:2013
- Inlocuit prin SR EN ISO 11300-1:2026