EN
SR EN 9103:2015
Serie aerospaţială. Sisteme de management al calităţii. Managementul variaţiilor caracteristicilor cheie
This standard is primarily intended to apply to new parts and products, but can also be applied to parts currently in production. The standard shall be applicable to all production processes that influence the variation of KCs, as well as maintenance processes in which KCs are identified. It applies to assemblies and all levels of parts within an assembly, down to the basic materials including castings and forgings, and to organizations that are responsible for producing the design characteristics of the product. It does not apply to lab-scale, pilot, or pre-production processes. However, particular management of some KCs might be required using other methods than those described in the standard, during these phases of a programme, when required by the customer or deemed appropriate by the organization (e.g., Engineering department requirement). The variation control process begins with product definition, typically an engineering drawing or specification which identifies KCs, and leads to a variation management program for those KCs. This process may also be used for produce
Status :
Anulat
Data aprobării : 29.05.2015
Data anulării : 31.05.2024
Număr de pagini : 19
ICS : 03.100.70 Sisteme de management,03.120.10 Managementul calitatii si asigurarea calitatii,49.020 Aeronave si vehicule spatiale în general
Comitet tehnic : 72 - Aeronautică şi spaţiu
- Inlocuieste SR EN 9103:2006
- Inlocuit prin SR EN 9103:2023
- Modificat de SR EN 9103:2015/AC:2015